There are several ways to install the BE Fuelsaver® correctly: We recommend an installation through an expert! It usually takes only a few minutes.
You can find an installation guide in pdf-form here:
Some vehicles have a filter or a lid/ball valve built in before the tank (from construction year 2006) Then please choose another installation method.
The connecting tube is in some cases welded to the tank. In this case please choose another installation method.
When choosing this installation method, the tank should be almost empty, as fuel could be spilled.
With one customer, the installation did not show any effect, as the BE Fuelsaver® lay on a place where it had no contact to the fuel.
Some filters have a built-in-cartridge which means that there is not enough space for the BE Fuelsaver® in the filter.
If the wall thickness of the pipe is more than 2mm, the effect of the BE Fuelsaver® is close to zero as the stick is too far away from the fuel (i.e. thick rubber hose of jeeps, or coat against the cold in Finnish vehicles).